----------------------------------------------------------------------------------------------------------------------------- ----------------------
Note:
• To configure LDAP sync, please go to UCM6100 Web GUI→Extension/Trunk→VoIP Trunk. You will see
"Sync LDAP Enable" option. Once enabled, please configure password information for the remote peer
UCM6100 to connect to the local UCM6100. Additional information such as port number, LDAP outbound
rule, LDAP Dialed Prefix will also be required. Both the local UCM6100 and remote UCM6100 need enable
LDAP sync option with the same password for successful connection and synchronization.
• Currently LDAP sync feature only works between two UCM6100s.
• (Theoretically) Remote BLF monitoring will work when the remote PBX being monitored is non-UCM6100
PBX. However, it might not work the other way around depending on whether the non-UCM6100 PBX
supports event list BLF or remote monitoring feature.
----------------------------------------------------------------------------------------------------------------------------- ----------------------
To Next Page
Loading...
Need help?
General
