FC2250-UM-251-9370 7-72
7. DISASSEMBLY AND ADJUSTMENT
7.8 Replacing the Electrostatic Adhesion Plate
(This operation requires three persons.)
7.8.1 Peeling Off the Electrostatic Adhesion Plate
(1) Turn off the power and remove the high-voltage power supply cable connectors (P34 and J34) at the
rear of the writing panel.
(2) Remove the Y bar (See section 7.5.1).
(3) Cut into the electrostatic adhesion plate at intervals (50-100 mm) that will make it easy to peel off
the electrostatic adhesion plate. If this scratches the aluminum plate underneath, polish away the
unevenness with #1500 sandpaper.
(4) Peel off the electrostatic adhesion plate, using force if necessary. Using pliers or the like makes it easy.
(5) Remove any remaining double-sided tape and glue. Sprinkle on ECT-1 toner cleaning uid (available
from Graphtec) and leave for 1 or 2 minutes. Scrape off with some sort of scraper (e.g. spatula).
(6) When everything has been removed from the aluminum plate, wipe it off with ethyl alcohol.
To Next Page
Loading...
