GRAPHTEC FC2250 - The X Or Y Belt Was Replaced; The Y Bar Was Removed

FC2250-UM-251-9370 8-5
8. ELECTRICAL ADJUSTMENTS
8.2.7 The X or Y belt was replaced
When the X or Y belt was exchanged, an electric adjustment is executed by the following procedure.
8.9 Adjusting the Home Position
8.5 Set the DIP Switches setting to the adjustment mode
End of Adjustment
8.5 Set the DIP Switches setting to the normal mode
8.12 Adjusting the Distance Accuracy and the perpendicularity
8.2.8 The Y bar was removed
When the Y bar was removed, an electric adjustment is executed by the following procedure.
8.9 Adjusting the Home Position
8.5 Set the DIP Switches setting to the adjustment mode
End of Adjustment
8.5 Set the DIP Switches setting to the normal mode
8.12 Adjusting the Distance Accuracy and the perpendicularity