GRAPHTEC FC2250 - The Pen Block Was Replaced; The X Home Sensor Was Replaced

FC2250-UM-251-9370 8-3
8. ELECTRICAL ADJUSTMENTS
8.2.2 The pen block was replaced
When the pen block was exchanged, an electric adjustment is executed by the following procedure.
8.9 Adjusting the Home Position
8.10 Adjusting the Pen Height
8.11 Adjusting the Pen Force
8.13 Adjusting the Pen Interval
8.14 Adjusting the Registration Mark Sensor Sensitivity
8.15 Adjusting the Offset of the Registration Mark Sensor
8.5 Set the DIP Switches setting to the adjustment mode
End of Adjustment
8.5 Set the DIP Switches setting to the normal mode
8.2.3 The X home sensor was replaced
When the X home was exchanged, an electric adjustment is executed by the following procedure.
8.9 Adjusting the Home Position
8.5 Set the DIP Switches setting to the adjustment mode
End of Adjustment
8.5 Set the DIP Switches setting to the normal mode