FC2250-UM-251-9370 7-37
7. DISASSEMBLY AND ADJUSTMENT
How to reinstall the Y bar
(1) Reattach the Y bar in the reverse order in which it was detached.
(2) Temporarily attach the Y bar along the line drawn in the section 7.5.2, “Preparations Before Detaching
the Y bar”.
(3) Adjust the Y bar height from the front frame and rear frame to 31.5 mm.
And adjust the Y bar frame clearance from the control panel frame to 2 mm.
(4) Conrm the clearance for the front Y bar frame (See the section 7.5.3).
(5) Mount the pen block in the reverse order in which it was detached.
• After using the pen block adjustment jig to adjust the height of the pen block, secure the pen block in
place.
(6) Adjust the right-angle for the Y bar (See the section 7.5.4).
(7) Adjust the distance adjustment by the electrical adjustment.
NOTE: When the Y bar is moved manually from side to side while the plotter is turned off, be sure to detach
the three connectors which connect the control box to the plotter’s main unit. Failure to remove these
connectors may cause the gears to slip or not mesh properly.
To Next Page
Loading...
