150
Program description - Phase settings | Winged models
Example:
Pha1
Pha2
Pha3
Name
Pha4
Pha5
+
+
–
–
3.0s
2.0s
0.1s
0.1s
Sw.time
Normal
Launch
Dist.
4.0s
The switchover time from any other phase to Phase 1
«normal» will take 4,0 s.
The time for a switchover from, for example, Phase 1
to Phase 3, is set to 2,0 s and the time for a switcho-
ver from Phase 1 or 3 to Phase 2 “Launch” is 3,0 s.
Such asymmetric transition times can be useful when,
e. g. switching between extremely different flight phas-
es, such as between aerobatics and normal flight.
A simultaneous tap on the or keys of the right
four-way button (CLEAR) will reset the time in the cur-
rently active value field back to 0,1 s.
Note:
The “switch time” set here applies uniformly
to all settings that are specic to ight phas-
es, and thus to all mixers activated in the
»Wing mixers« menu, see page 166. Accordingly,
the transition between ight phase-specic mixers
does not occur abruptly. However, if individual servos
are to be switched without a delay then these can be
dened accordingly in the »Non-delayed chan«
menu on the mc-20 HoTT, see page 157.
To Next Page
Loading...
