GRAUPNER mc-16 Programming Manual

175
Program description - Wing mixers
FL
+100%
fl.pos
EL FL 0%0%
+100%
FLAP
normal
0%
EL FL Off.
0%
–––
In addition, the settings for “Aile(ron) diff(erential)” are
not found on the “multi-flap menu”, as with “2AIL
2/4FL”, but one level higher in the “Wing mixers” menu,
see the screenshot on start of this section.
Model type: “2AIL 2FL“
If servos have been connected to the receiver as de-
scribed on page 65 and selected accordingly in the
»Model type« menu, page 98, then the abbrevia-
tions “AILE” and “FLAP” refer to the following flaps:
AI
left
FL
left
FL
right
AI
right
Since the options available on the wing mixer menu
and its sub-menus vary according to the number of
aileron and flap servos specified on the »Model type«
menu, page 98, the list contains only those set-up
options available for the given model.
This means that if values are preset to “2AIL 2FL”, then
all configuration options for the aileron pair …
FL
0%
0%
fl.pos
EL FL 0%0%
0%
AILE
normal
Diff.
0%
Ail-tr
AI
+100%
+100%
EL FL Off.
0%
–––
… are shown, and – one “step” to the right – all options
for the flap pair as well:
FL
0%
+100%
fl.pos
EL FL 0%0%
+100%
FLAP
normal
Diff.
0%
Ail-tr
AI
0%
0%
EL FL Off.
0%
–––
Moving one further column to the right, however – to
the “FLAP2” column – is not possible.
Model type: “2AIL 4FL”
If you have connected the servos to the receiver as
described on page 65, and selected them for the
appropriate tasks in the »Model type« menu, see page
98, of the twelve-channel
mc-20 HoTT transmit-
ter only, then the abbreviations “AIL”, “FL” and “FL2”
refer to the following control surfaces:
AI
left
FL
left
FL2
left
FL2
right
FL
right
AI
right
Since the options available on the wing mixer menu
and its sub-menus vary according to the number of
aileron and flap servos specified on the »Model type«
menu, page 98, the list contains only those set-up
options available for the given model.
This means that if values are preset to “2AIL 4FL”, then
all configuration options for the aileron pair …
FL
0%
0%
fl.pos
EL FL 0%0%
0%
AILE
normal
Diff.
0%
Ail-tr
AI
+100%
+100%
EL FL Off.
0%
–––
… are shown, and – one “step” to the right – all options
for the first flap pair …
FL
0%
+100%
fl.pos
EL FL 0%0%
+100%
FLAP
normal
Diff.
0%
Ail-tr
AI
0%
0%
EL FL Off.
0%
–––

GRAUPNER mc-16 Specifications

General

Brand	GRAUPNER
Model	mc-16
Category	Remote Control
Language	English