m
m
s
If attached, this display will depict the altitude (in m)
relative to location, starting location as well as the
current rate of ascent/descent (in m/s) from data origi-
nating from the Vario integrated into the GPS-/Vario
module (No. 33600).
Speed display
0
km/h
If the corresponding sensor is available, this screen
displays the model’s actual speed over the ground.
AIR ESC
RX–S QUA: 100%
RX–S ST : 100%
TX–dBm: 33dBm
RX–dBm: 33dBm
RX–SPG.:4.8 TMP
V–PACK: 10ms
CH OUTPUT TYPE:ONCE
RECEIVER
GENERAL
ELECT. AIR
VARIO
GPS
AIR ESC
0
0
0rpm
0.0A
0.0A
0
0mAh
0.0V/ 0.0V
0( 0)°C
0( 0)°C
This screen displays the data generated by a brushless
speed controller with internal telemetry, No. 33718 to
33770 and 33850 (correct at time these instructions
were revised), which is connected to the receiver.
Regardless of any regulator values the operating tem-
perature and the maximum temperature reached in the
current energizing period of a telemetry-capable elec-
tric motor is visualized in the second line of the display.
Key, reading from top left to bottom right:
Value Explanation
V Left-hand value: actual battery voltage
Right-hand value: actual battery voltage
in present power-on period
°C Graphical representation and left-
hand value: actual speed controller
temperature
Value in brackets: maximum controller
and motor temperature in actual power-
on period
mAh Battery capacity consumed in actual
power on section
A Centre and bar display: actual current
Right-hand value: maximum current in
present power-on period
rpm Centre and bar display: actual rotational
speed of the motor connected to the
speed controller.
Right-hand value: maximum rotational
speed in present power-on period
RPM display
rpm
0
0
This screen displays the current rotational speed of the
motor connected to the brushless speed controller.
Current / consumption display
0.0A
0.0A
0
0mAh
This screen displays the actual current consump-
tion, the peak drain which has occurred in the present
power-on period, and the capacity drawn from the bat-
tery connected to the brushless speed controller within
the same period.
Voltage, current, speed and temperature display
This display visualizes the current power supply voltage
of the motor, the power currently flowing through the
controller and the speed of the drive motor and left the
operating temperature of the brushless controller and
the right temperature of a telemetry-capable drive mo-
tor.
To Next Page
Loading...
Need help?
General
