Great Wall hover - Page 170

Cautions
Do not clamp the drive shaft bushing too tightened by the bench
vice to avoid the deformation.
failure Possible causes Method
Noise
The spline of universal-joint fork is worn
The intermediate bearing is worn
The cross-axle bearing is worn or jammed
Replace the universal-joint
fork
Replace the intermediate
bearing
Replace the cross-axle bearing
vibration
Runout of drive shaft
Unbalance of drive shaft
The rear bearing bushing of transmission
extended housing is worn
The spline of universal-joint fork is jammed
Replace the drive shaft
Replace the drive shaft
Replace the bushing
Replace the universal-joint
fork