Great Wall hover - Installation of Rear Axle

8. Check the inner oil seal for wear or damage.
9. Remove the inner oil seal
Use the special tools to remove the inner oil seal.
10. Install the new inner oil seal
a. Coat the lip of oil seal with proper HP-R grease.
b. Use the special tools to knock in the new oil seal.
Installation of rear axle
1. Install the halfaxle assembly in the axle housing
a. Use the kerosene to clean the semiaxle and inner oil seal holder.
b. Assemble the halfaxle spline and halfaxle gear spline firstly,
then use the brass rod to beat knock the halfaxle assembly into
the axle housing.
Caution: Protect the lip of inner external oil seal and pull-wire
assembly during assembly; do not damage the oil sleeve
assembly; align the brake bolt with the flange bolt of rear axle.
Tightening force: 95-105N
m
2. Install the rear brake disc
3. Install the brake caliper
Tightening force: 95-105N m
4. Connect the manual brake wire.
5. Install the wheel.
6. Discharge the air of brake system by test.
special tools
special tools
brake disc
axle housing
flange
halfaxle
assembly