Great Wall hover - Disassembly of Rear Housing Assembly

Disassembly of rear housing assembly
1.Remove the M8
18 hexagon bolt and the lock plate
Caution: When install the M8
18 hexagon bolt, the tightening
torque is 14-19N
m
2.Remove the odometer driven gear assembly
Use the special tools to remove the odometer driven gear assembly
3.Remove the rear cover assembly
Caution: When install 6 M10
1.25 30 hexagon bolts, the tightening
torque is 14-19N
m
b.Use the plastic hammer to knock the rear cover slightly and take out
the rear cover
c.Take out the adjusting shim
Caution: It should select the adjusting shim as follows when
install it.
mark