Great Wall hover - Installation Sequence; Operations before Removal; Some Points for Installation

Safety airbag-22
1. Operations before removal
a. Place the ignition switch in OFF position.
b. Remove the accumulator negative and well preserve it somewhere or wrap it with tape.
2. Removal procedure.
a. Central channel’s side panel (or remove the co-instrument panel)
b. Remove the connector clip connecting with the safety airbag ECU
3. Installation sequence
a. SRS-ECU;
b. Install the connector clip connecting with the safety airbag ECU
c. Central channel’s side panel (or remove the co instrument panel)
d. Connect the grounding jumper.
4. Some points for installation
a. SRS-ECU installation
b. Post-installation test
Place the ignition switch in ON position
SRS alarm lamp flashes in 6 seconds and extinguishes.
c. If not extinguishes, the failure test and troubleshooting must be done.
5. Test
a. Whether the depression, crack or deformation is with the SRS-ECU shield.
b. Whether the terminal is broken or deformed.
Caution: The SRS-ECU safety airbag will not work normally if the SRS-ECU is not correctly installed.
Caution: The SRS-ECU with depression, crack or deformation must be replaced with a new one.
For the inspection of SRS-ECU besides the previous refer to related item of troubleshooting