Great Wall hover - Disassembly of Lower Suspension Arm

Lower suspension arm
Disassembly of lower suspension arm
1.The disassembly of the front hub and steering knuckle
assembly includes the removal of vibration damper,
stabilizer bar and steering cross rod.
(Refer to the section “Front Hub and SteeringKnuckle”)
2. Disassembly of torsion bar spring
(Refer to section “Torsion Bar Spring”)
3. Remove the front shaft of lower arm
a. Make the assembly mark on the adjusting cam
b. Remove the nut and front shaft of lower arm.
4. Screw off the rear shaft of lower arm
Screw off the nut; remove the rear shaft of lower arm shaft and
remove the lower suspension arm.