Brake-3
Troubleshooting (continued)
failure cause Inspection content
The brake generates the
crack clatter during
operation.
(drum brake)
The brake shoe is blocked in the rear apron flange
The rear apron flange is worn
The brake shoe pull-out piece spring is loose or lost
The fixed bolt of rear apron is loose (disc brake )
Brake block support plate is loose or lost
Installation bolt is loose
Filled with lubricated oil
Replace the lubricant flange
Replace
tighten
replace
tighten
It has the rustle or rattler
when use the brake
The brake shoe gasket or brake block is worn
The brake caliper and wheel or rotor are disturbed
mutually
The dustproof cover and rotor, rear apron and brake
drum are disturbed mutually
Failure of other brake system component
Tyre generates the abrasion with the tyre and chassis
Replace, if the scratch is heavy,
then fine machine the brake drum or
rotor again
Replace it according to requirement
Correct or replace
Repair or replace it according to
requirement
Check or maintain
It has the squeak, continuous
scream, rattler or vibration
noise when use the brake .
Caution: The abrasion
material in the brake will
generate the inherent noise
and heat during the
abrasion, then emit the
heat. So it is normal that
generate the squeak by
accident. The condition
will be serious in extreme
environment, such as cold,
hot, high humidity,
snowing, saliferous and
mud. The accident squeak
will not cause the fatal
failure of the brake, and
will not reduce the effective
performance of the brake.
The brake drum and brake shoe gasket, rotor and
brake block is worn or scratched.
The brake pad or block is dirty, with oil or smoothed.
The brake pedal or assistor push bar is adjusted
incorrectly
(disc brake )
The brake block silencing plate is lost or damaged.
The abrasion of the brake block makes the brake
block abrasion indication plate contacts the rotor
The brake caliper has burr or is corrosive
(drum brake)
The pull-out piece spring of brake shoe is soft,
damaged or improper. The pull-out piece spring pin
and spring of brake shoe is loose or damaged; and
rear apron flange has crack
Check, repair or replace
clean or replace
check, replace
check and adjust
replace
replace
clean or remove the flash
check, repair or replace