Clutch-8
b. Use special tools to install the guide bearing
Remarks: Install the guide bearing into the flywheel, make
sure that the bearing can rotate well.
6. Check to see whether there is wearing of the diaphragm spring
Use caliper to check the wearing depth and width of the diaphragm
spring
Limit value: maximum depth 0.6mm
Maximum width 5.0mm
7. Check the throwout bearing
Rotate the bearing with hand along the axis direction.
If the bearing can not rotate or the resistance is too large, it is necessary
to replace the throwout bearing.
Remarks: The bearing is permanent lubricated, so cleaning
and lubricating is unnecessary.
special tools
To Next Page
Loading...
