1-8
One-Step Patch Uninstallation
You can use the undo patch install command to uninstall patches from all the member devices. The
patches then turn to the IDLE state. This equals the execution of the commands patch deactive and
patch delete on each member device.
Follow these steps to uninstall the patches in one step:
To do… Use the command… Remarks
Enter system view
system-view
—
Uninstall the patches
undo patch install
Required
Step-by-Step Patch Uninstallation
Step-by-Step Patch Uninstallation Task List
Task Remarks
Stop Running Patches Required
Deleting Patches Required
Stop Running Patches
After you stop running a patch, the patch state becomes DEACTIVE, and the system runs in the way
before it is installed with the patch.
Follow the steps below to stop running patches:
To do… Use the command… Remarks
Enter system view
system-view
—
Stop running the specified
patches
patch deactive patch-number
slot slot-number
Required
Deleting Patches
Deleting patches only removes the patches from the memory patch area, and does not delete them
from the storage medium. The patches turn to IDLE state after this operation. After a patch is deleted,
the system runs in the way before it is installed with the patch.
Follow the steps below to delete patches:
To do… Use the command… Remarks
Enter system view
system-view
—
Delete the specified patches
from the memory patch area
patch delete patch-number
slot slot-number
Required
To Next Page
Loading...
