1-18
z The SNMP-related configurations are retained when a cluster is dismissed or the member devices
are removed from the whitelist.
z For information about SNMP, refer to SNMP Configuration in the System Volume.
Configuring Web User Accounts in Batches
Configuring Web user accounts in batches enables you to configure on the management device the
username and password used to log in to the devices (including the management device and member
devices) within a cluster through Web and synchronize the configurations to the member devices in the
whitelist. This operation is equal to performing the configurations on the member devices. You need to
enter your username and password when you log in to the devices (including the management device
and member devices) in a cluster through Web.
Follow these steps to configure Web user accounts in batches:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Configure Web user accounts
in batches
cluster-local-user username password
{ cipher | simple } password
Required
If a cluster is dismissed or the member devices are removed from the whitelist, the configurations of
Web user accounts are still retained.
To Next Page
Loading...
