v
_____________________________________________________________________________________________
______________________________________________________________________________________________
DANGER
To avoid electric shock, do not remove the product's case. The internal
components of the product carry high voltages and may become very
hot during operation.
The vinyl shield on the 9615 H.V. TEST LEAD alligator clip is not high
voltage insulated. Do not touch when high voltage is applied.
WARNING
To avoid electric shock, do not allow the product to get wet, and do not
use it when your hands are wet.
To avoid electric shock, be sure to connect the protective ground
terminal to a grounded conductor.
To avoid electrical accidents and to maintain the safety specifications
of this instrument, connect the power cord provided only to a 3-contact
(two-conductor + ground) outlet.
Before turning the product on, make sure the source voltage matches
that indicated on the product's power connector. Connection to an
improper supply voltage may damage the product and present an
electrical hazard.
Replace the fuse only with one of the specified characteristics and
voltage and current ratings. Using a non-specified fuse or shorting the
fuse holder may cause a life-threatening hazard.
Fuse type: 250VT10AL (100-120 V), 250VT5AL (200-240 V)
To avoid electric shock when measuring live lines, wear appropriate
protective gear, such as insulated rubber gloves, boots and a safety helmet.
CAUTION
To avoid electrocution, turn off the power to all devices before plugging or
unplugging any of the interface connectors.
To avoid damaging the power cord, grasp the plug, not the cord, when
unplugging the cord from the power outlet.
To avoid damaging H.V. TEST LEAD, do not kink or pull on the leads.
For safety reasons, when taking measurements, only use the 9615 H.V.
TEST LEAD provided with the product.
To avoid damage to the product, protect it from vibration or shock during
transport and handling, and be especially careful to avoid dropping.
Failure to observe the following precaution may result in bodily injury.
This instrument weighs approximately 18kg. When lifting or moving the
unit, it is strongly recommended that two capable persons hold the
instrument at both ends of the bottom to prevent drop or damage.
The instrument is heavy. When transporting it, follow your company's
workplace safety standards to assure safety (for example, by wearing non-
slip gloves and protective footwear).
To avoid electric shock, do not exceed the lower of the ratings shown on the
instrument and test leads.
NOTE
Do not use the product near a device that generates a strong electromagnetic field or
electrostatic charge, as these may cause erroneous measurements.
This product may cause interference if used in residential areas. Such use
must be avoided unless the user takes special measures to reduce
electromagnetic emissions to prevent interference to the reception of radio
and television broadcasts.
Notes on Use
Follow these precautions to ensure safe operation and to obtain the full
benefits of the various functions.
To Next Page
Loading...
