Hioki 3153 - Chapter 3 Withstand Voltage Modetesting Method

19
_____________________________________________________________________________________________
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
Flashing
NOTE
Note that the output waveform may be distorted when conducting an AC withstand
voltage test for a voltage-dependent device or object (e.g., ceramic capacitor).
Excessivel
y
lar
g
e distortion ma
y
dama
g
e the device or tested ob
j
ect.
Chapter 3
Withstand Voltage Mode
Testing Method
This chapter describes how to set withstand-voltage mode test conditions and
the proper testing procedure.
Read chapter 2, and make the necessary preparations for testing.
Press the
W
key to enter withstand-voltage mode.
(The W lamp above the key to the left lights.)