Hioki 3153 - Setting the Type of Test Voltage

29
_____________________________________________________________________________________________
3.3 "SETTING" State
______________________________________________________________________________________________
3.3.5 Setting the Type of Test Voltage
AC 50 Hz
For AC withstand-voltage tests. The frequency of the test
voltage is 50 Hz.
AC 60 Hz
For AC withstand-voltage tests. The frequency of the test
voltage is 60 Hz.
DC
For DC withstand-voltage tests.
Test-voltage type: AC 50 Hz
NOTE
The ripple voltage caused by the output of the DC withstand-voltage is not more
than 6% of the set test-voltage value.
In the withstand-voltage mode, the following types of test voltages can be
selected:
1. If no flashing cursor is displayed in the withstand-voltage mode READY
state, press either the / key to display the cursor in the AC or DC
position.
2. Change the test-voltage type using the
/
keys. Select from AC 50 Hz,
AC 60 Hz or DC.
3. To finalize the test settings, press the
STOP
key.