Hioki 3153 - Displaying Errors

231
_____________________________________________________________________________________________
12.4 Displaying Errors
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Err000
Interlock state. (See Section 9.1.4)
Err001
Analog-circuit error (PWM). Turn OFF the power switch on
the unit, and then turn it ON again. If the unit is not
restored, it may be malfunctioning.
Contact your sales agent or nearest sales office.
Err002
Analog-circuit error (Vcc). This error can be caused by an
abnormality in the power voltage, such as an instantaneous
stop. Check the power voltage. Turn OFF the power switch
on the unit, and then turn it ON again. If the unit is not
restored, it may be malfunctioning.
Contact your sales agent or nearest sales office.
Err003
System error has occurred. Turn off the main power switch,
then turn it on again.
If this action fails to reset the system, perform the all-system
reset. (See 12.6, "System Reset.")
If this action also fails to reset the system, the system may
be malfunctioning.
Contact your sales agent or nearest sales office.
Err O.H
Overheat error. The inside of the unit is overheated due to
an overload or the like. (See Section 11.1.1) Leave the unit
for several minutes without turning OFF the power switch. If
the unit is not restored, it may be malfunctioning.
Contact your sales agent or nearest sales office.
12.4 Displaying Errors
If an error occurs, the 3153 displays the following on the screen.
If the displayed number is outside the test setting range, follow the
instructions for "Err003" in the table above.
When errors other than the above are displayed, the unit may be
malfunctioning. Contact your sales agent or nearest sales office.