86
_____________________________________________________________________________________________
6.2 Displaying the "READY" State
______________________________________________________________________________________________
File number
PG.LOAD
Moves to the program-file loading window.
(See Section 6.4)
SHIFT
＋
STOP
Displays the Optional functions setting screen.
(See Chapter 7)
START
Test Start (See Section 6.5)
LOCK
Key-lock function (See Section 6.2.1)
6.2 Displaying the "READY" State
In the READY state, the unit is always ready to start a test. The
READY
lamp remains lit to indicate the READY state.
・
When you enter the program mode by pressing the
PROG
key, the step-1
settings of the file that was loaded previously are displayed.
・
From this state, you can enter the "program setting state," perform
program-file loading, and set optional functions.
Danger lamp
Indicates that a voltage is being output. This lamp remains lit as long as a
voltage is being applied to the output terminal. It does not light up in the
READY state.
Analog voltmeter
Indicates the voltage value being output. In the READY state, the value
remains at 0 kV.
External I/O
The
READY
――――――――――
signal is ON when
READY
is lit on the fluorescent indicator.
The
READY
――――――――――
signal is turned OFF when
READY
is not lit.
Key Operations
To Next Page
Loading...
