Hioki 3153 - Installation of the Unit

16
_____________________________________________________________________________________________
2.8 Installation of the Unit
______________________________________________________________________________________________
NOTE
The noise generated by this unit may affect equipment located around the unit.
Install the unit in such a way that the vent holes on both sides and at the rear of
the unit are not blocked
,
so that the unit can function normall
y
.
2.8 Installation of the Unit
Temperature: 0 to 40
℃
Humidity: 80% RH or less (no condensation)
Avoid the following locations:
・
Subject to direct sunlight.
・
Subject to high levels of dust, steam, or corrosive gases (Avoid using the
equipment in an environment containing corrosive gases (e.g., H
2
S, SO
2
,
NI
2
,andCI
2
) or substances that generate harmful gasses (e.g., organic
silicones, cyanides, and formalins)).
・
Subject to vibrations.
・
In the vicinity of equipment generating strong electromagnetic fields.