Hioki 3153 - Screening in PASS State

38
_____________________________________________________________________________________________
3.5 "PASS" or "FAIL" Determination
______________________________________________________________________________________________
3.5.2 Screening in "PASS" State
1 2 3
4
5
6
1 Measured
voltage value
Indicates the voltage in the PASS state.
2 Upper-limit value
icon and Lower-
limit value icon
The symbol appears when the upper-limit value is set,
and the symbol
appears when the lower-limit value is
set.
3 Measured
current value
Indicates the value of the current flowing between the HIGH
and LOW terminals in the PASS state
4 Test time
elapsed
Displays the time in which the test has been completed. In
PASS state, "
0.0s
" is displayed.
5 Test-voltage type
Indicates the test type (AC 50 Hz, AC 60 Hz or DC.)
6 PASS
Indicates that the unit is in the PASS state.
Danger lamp
Indicates that a voltage is being output. The lamp stays on during the test
(including ramp-up time and ramp-down time). In the withstand-voltage
mode, this lamp remains lit even after completion of the test, if a voltage
higher than the safety voltage (approximately AC 0.03 kV or approximately
DC 0.06 kV) has flowed between output terminals.
Analog voltmeter
Indicates the voltage being output in withstand-voltage test. The analog
voltmeter is not held even if the PASS Hold function is disabled.
Indicates the voltage value being output.
External I/O
The
PASS
――――――
signal is turned ON when
PASS
on the fluorescent indicator is lit.
As long as the PASS state is held, the
PASS
―――――――
signal remains ON. The
PASS
―――――――
signal is turned OFF when the
PASS
light on the fluorescent indicator goes
out.
If voltage remains in the output-voltage terminal following termination of a
test, the
H.V.ON
――――――――――
signal remains ON. When the
DANGER
lamp goes out,
H.V.ON
――――――――――
signal is immediately turned OFF.