Hioki 3153 - Resetting the System

233
_____________________________________________________________________________________________
12.6 Resetting the System
______________________________________________________________________________________________
Test type AC50 Hz
Test-voltage value 0.20 kV
Upper-limit value 0.2 mA
Upper-limit value setting OFF
Lower-limit value 0.1 mA
Test time setting ON
Test time 0.3 s
Ramp-up time setting OFF
Ramp-up time 0.1 s
Ramp-down time setting OFF
Ramp-down time 0.1 s
Test-voltage value 50 V
Upper-limit value setting OFF
Upper-limit value 9999 M
Ω
Lower-limit value 4000 M
Ω
Test time setting ON
Test time setting 0.3 s
Delay time setting OFF
Delay time 0.1 s
12.6 Resetting the System
The two system reset methods specified below can be used (the content to be
reset differs).
Method 1
Turn ON the main power switch while pressing the
SHIFT
key.
Contents to be reset: (1)
＋
(2)
＋
(3)
Method 2 (All system reset)
Turn ON the main power switch while pressing the
W
+
PROG
+
SHIFT
keys.
Contents to be reset: (1)
＋
(2)
＋
(3)
＋
(4)
＋
(5)
(1) Withstand-voltage mode
(2) Insulation resistance mode