Hioki 3153 - Page 227

214
_____________________________________________________________________________________________
10.8 GP-IB Command Reference
______________________________________________________________________________________________
Syntax
∗SRE <data>
<data>
0to255
(NR1)
Function
Sets a pattern which is used to mask the status byte register (STB) to the service request
enable register (SRSR).
The numerical value can be in NRf format, but any digits after the decimal point will be
rounded.
The settings of unused bits (bits 1, 2, 3, and 7) and bit 6 are disregarded.
When the power is turned on, the data is reinitialized to zero.
Example
Bits 0 and 5 of SRER are set to 1.
Transmission ∗SRE 33
Error
If <data> is other than numerical value described above, an execution error occurs.
Service re
q
uest enable re
g
ister
(
SRER
)
128 64 32 16 8 4 2 1
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
Unused Unused
ESB MAV
Unused Unused Unused
ESE0
Syntax
∗SRE?
Function
Returns the set contents of the service request enable register (SRER) as a numerical value in
NR1 format between 0 and 255.
Example
Queries the service request enable register (SRER).
Transmission ∗SRE?
Response 33
Bits 0 and 5 of SRER have been set to 1.
Error
If the response message is longer than 300 bytes, a query error is generated.
Service re
q
uest enable re
g
ister
(
SRER
)
128 64 32 16 8 4 2 1
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
Unused
×
ESB MAV
Unused Unused Unused
ESE0
∗SRE
Sets the service request enable register.
∗SRE?
Queries the service request enable register (SRER).