189
Installation
Input codes Mark Description
i - 10 Forced heating
Forced Heating mode by input of contact signal, Heating can also be changed over by master
controller.
Closed: Forced Heating mode Open: No action.
i - 11 Forced cooling
Forced Cooling mode by input of contact signal, Cooling can also be changed over by master
controller.
Closed: Forced Cooling mode Open : No action.
i - 12 Power meter 2
Input used as kW/h pulse count for Energy data recording, used to count energy data or the total
energy data.
i - 13
Cycle 1 and 2 ECO
mode
the indicated parameter in space heating mode or space cooling mode.
i - 14 Cycle 1 ECO mode
indicated parameter in space heating mode or space cooling mode.
i - 15 Cycle 2 ECO mode
indicated parameter in space heating mode or space cooling mode.
i - 16 Force OFF
Force OFF the unit include Water Cycle 1, Water Cycle 2, DHW and SWP. Switch ON/OFF of
Closed: Forced OFF the unit include Water Cycle 1, Water Cycle 2, DHW and SWP. Open: No
action.
i - 17 SG Ready Input 2
operating modes.
To Next Page
Loading...
