Honeywell UDC2800 - Page 221

Table 5-23: Ramp/Soak Profile Example
Prompt Function Segment Value
Soak Deviation Deviation Value 0
Program
Termination
Controller Status Last SP
Program End State Controller
State at end
Hold
Key Reset/Rerun Reset SP Program Disable
Hot Start PV Hot Start
Program Initialization or power up in
SPP
Disable
Start Segment Start Seg. 1
End Segment End Seg. 8
Ramp Unit Engr. Unit for Ramp Time
Recycles Number of Recycles 1
Segment 1 Ramp Ramp Time 1 1 hr.
Segment 2 SP Soak SP 2 300
Segment 2 Time Soak Time 2 1 hr:30
min.
Segment 3 Ramp Ramp Time 3 1 hr.
Segment 4 SP Soak SP 4 400
Segment 4 Time Soak Time 4 1 hr.
Segment 5 Ramp Ramp Time 5 0 hr:0 min
Segment 6 SP Soak SP 6 250
Segment 6 Time Soak Time 6 3 hr:0 min.
Segment 7 Ramp Ramp Time 7 2 hr:30
min.
Segment 8 SP Soak SP 8 500
Segment 8 Time Soak Time 8 0 hr:30
min.
221
Chapter 5 - Monitoring and Operating the Controller