Honeywell UDC2800 - Page 333

Parameter
Description
Register
Address
Data
Type
Access
Data Range or
Enumerated Selection
Hex Decimal
Rate 3 Min
See Note 1
E 14 FP R/W 0.00 to 10.00
Reset Mins/Rpt
3
See Note 1
F 15 FP R/W 0.02 to 50.00
Reset Rpts/Min
3
See Note 1
10 16 FP R/W 0.02 to 50.00
Gain 4
See Note 1
11 17 FP R/W 0.01 to 1000 Gain
Proportional
Band 4
See Note 1
12 18 FP R/W 0.1 to 1000 Proportional
Band
Rate 4 Min
See Note 1
13 19 FP R/W 0.00 to 10.00
Reset Mins/Rpt
4
See Note 1
14 20 FP R/W 0.02 to 50.00
Reset Rpts/Min
4
See Note 1
15 21 FP R/W 0.02 to 50.00
Cycle Time 1
Sec
80B 2059 INT16 R/W 1 to 120 seconds
Cycle Time 2
Sec
80C 2060 INT16 R/W 1 to 120 seconds
Note 1: Writes to these locations are not available when Accutune is enabled.
333
Chapter 11 - Modbus RTU Function Codes 20&21