Honeywell UDC2800 - Page 6

Setting a Failsafe Output Value for Restart After a Power Loss 210
Setting Failsafe Mode 211
Setpoint Rate/Ramp/Program 212
Setpoint Rate 213
Setpoint Ramp 214
Setpoint Ramp/Soak Programming 216
Chapter 6 - Input Calibration 226
Overview 227
Minimum and Maximum Range Values 228
Preliminary Information 230
Input 1 or 2 Set Up Wiring 232
Thermocouple Inputs using a Millivolt Source 232
RTD Inputs 232
Millivolts, Volts or Thermocouple Differential Inputs 233
Milliamperes 234
Input 1 or 2 Calibration Procedure 234
Restore Input Factory Calibration 238
Chapter 7 - Output Calibration 240
Overview 241
Current Output Calibration 241
Auxiliary Output Calibration 244
Position Proportional and Three Position Step Output Calibration 246
Restore Output Factory Calibration 250
Chapter 8 - Troubleshooting/Service 253
Overview 254
Troubleshooting Aids 255
Power-up Tests 256
Status Tests 257
6
Contents