Honeywell UDC2800 User Manual

Function
Prompt
Selections or Range
of Setting
Parameter Definition
ATTENTION: SP Ramp must be
disabled for SP Program prompts to
appear. If SP Rate is enabled, it does not
operate while an SP Program is running
.
Disable Disables setpoint programming.
Enable Enables setpoint programming.
NOTE: For more configurable
parameters of SP Program, see the table
SP Program configurable parameters.
Soak Deviation 0 to 99.999 Guaranteed Soak Deviation Value
The number selected will be the PV value (in
engineering units) above or below the setpoint
outside of which the timer of soak segment
halts.
0 means the soak deviation function is
disabled.
Program
Termination
Program Termination State
Last SP Hold at last setpoint in the program
Failsafe Manual mode/Failsafe output
Program End
State
Disable
Hold
It determines the program state after
completion.
Disable: SP Program Function is disabled.
Hold: SP Program Function is not disabled.
Key
Reset/Rerun
Reset/Rerun SP Program.
After configuration, press the Lower Display
key under the main screen, until you see To
Begin or Rerun. Then press the Increment key
or Decrement key, To Begin or Rerun will go
into effect.
85
Chapter 4 - Configuration

Honeywell UDC2800 Specifications

General

Control Modes	PID, ON/OFF, Manual
Mounting	Panel Mount
Display	Dual 4-digit LED
Input Types	Thermocouple, RTD, mA, mV, V
Output Types	Relay
Power Supply	100-240 VAC, 50/60 Hz
Communication	RS-485 Modbus RTU
Enclosure Rating	NEMA 4X