HP 8753E - Page 25

7-17. 10 MHz HI OUT Waveform from A14Jl
............
7-26
7-18. 25 MHz HI OUT Waveform from A14Jl
............
7-26
7-19. 60 MHz HI OUT Waveform from A14Jl
............
7-27
7-20. LC OUT Waveform at A14J2
.................
7-28
7-21. Al4 Generated Digital Control Signals
............. 7-30
7-22. H MB Signal at A14Pl-5 (Preset and 16 MHz to 31 MHz Sweep) .
7-31
7-23. Pulse Generator Output
...................
7-32
7-24. HighQuaiityComb’Ibothat3GHz
.............. 7-33
7-25. Stable HI OUT SiiaI in FRACN TUNE Mode
..........
7-34
7-26. Typical 1st IF Waveform in FRACN TUNE/SRC TUNE Mode
. .
7-35
7-27. FM Coil - Plot with 3 Point Sweep
..............
7-37
8-l. Equipment Setup
...................... 8-4
8-2. Typical Good Trace
.....................
8-5
8-3. 4 MHz REF Waveform
....................
8-7
8-4. Digital Data Lines Observed UsingL INTCOP as Trigger
....
S-10
8-5. Digital Control Lines Observed Using L INTCOP as Trigger
...
S-10
8-6. 2nd IF (4 kHz) Waveform
...................
8-12
8-7. Typical Trace with Sampler Correction On and Off
.......
8-13
9-l. Typical Return Loss Traces of Good and Poor Cables
......
9-5
9-2. Typical Smith Chart Traces of Good Short (a) and Open (b)
...
9-7
10-l. Internal Diagnostics Menus
..................
10-2
10-2. A9 CPU Switch Positions
...................
10-S
10-3. Service Feature Menus
....................
lo-18
104. Analog Bus Node 1
.....................
lo-27
10-5. AnaiogBusNode2
.....................
lo-28
10-6. Analog Bus Node 3
.....................
lo-29
10-7. AnalogBusNode4
.....................
lo-30
10-B. Analog Bus Node 6
.....................
10-31
10-9. Analog Bus Node 7
.....................
lo-32
10-10. Analog Bus Node 14
.....................
lo-35
10-11. Analog Bus Node 15
.....................
lo-36
10-12. Analog Bus Node 16
.....................
lo-37
10-13. Counter Readout Location
..................
lo-38
10-14. Analog Bus Node 18
.....................
10-39
10-15. Analog Bus Node 20
.....................
lo-40
10-16. Analog Bus Node 23
.....................
1041
10-17. Analog Bus Node 29
.....................
1044
10-18. Analog Bus Node 30
.....................
1045
10-19. Location of Firmware Revision Information on Display
.....
1047
11-l. Standard Connections for Fuli Two-Port Error-Correction
...
11-4
11-2. ‘ljpical EDF/EDR without and with Cables
..........
11-11
Contents-20