•
Number 2 Phillips screwdriver
1. Go to the rear of the BTI7802 chassis and unfasten the screw to remove the filter
cover.
NOTE: The cover is detachable when unfastened. The screw is captive in
the cover. Use the finger and thumb inserts on the filter cover as an aid to
detach the cover.
2. Remove the air filter from the channel and discard it.
3. Ensure the channel is free from debris before installing the new filter.
4. Install a new air filter.
Copyright © 2019, Juniper Networks, Inc.198
BTI7800 Series Hardware Overview and Installation Guide
To Next Page
Loading...
Need help?
General
