Juniper EX2200 Hardware Guide

Table 48: show interfaces ge- Output Fields (continued)
Level of OutputField DescriptionField Name
All levelsName of the logical interface.Logical interface
detail extensive noneIndex number of the logical interface, which reflects its initialization sequence.Index
detail extensive noneSNMP interface index number for the logical interface.SNMP ifIndex
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
All levelsInformation about the logical interface.Flags
All levelsEncapsulation on the logical interface.Encapsulation
detail extensive noneProtocol family.Protocol
detail extensiveNumber and rate of bytes and packets received (input) and transmitted (output)
on the specified interface.
NOTE: For logical interfaces on EX Series switches, the traffic statistics fields
in show interfaces commands show only control traffic; the traffic statistics do
not include data traffic.
Traffic statistics
extensiveEX Series switches do not support the collection and reporting of IPv6 transit
statistics.
IPv6 transit
statistics
extensiveNumber and rate of bytes and packets destined to and from the switch.Local statistics
extensiveNumber and rate of bytes and packets transiting the switch.Transit statistics
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
detail extensive noneRoute table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Route Table
detail extensiveNames of any input filters applied to this interface.Input Filters
detail extensiveNames of any output filters applied to this interface.Output Filters
detail extensiveInformation about protocol family flags.
If unicast reverse-path forwarding (RPF) is explicitly configured on the specified
interface, the uRPF flag is displayed. If unicast RPF was configured on a different
interface (and therefore is enabled on all switch interfaces) but was not explicitly
configured on the specified interface, the uRPF flag is not displayed even though
unicast RPF is enabled.
Flags
briefProtocol family configured on the logical interface. If the protocol is inet, the IP
address of the interface is also displayed.
protocol-family
detail extensive noneInformation about the address flags.Flags
Copyright © 2015, Juniper Networks, Inc.282
Network Interfaces for EX4300 Switches

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g