Koden MDP-621 - Page 97

Chapter 6 MDP-621/641/640
Plotter operation Operation manual
(a) Setting the mark number
Press the “M NO” key. The following soft menu and mark number settings box are displayed.
Enter the search start number and the search end number. If the ”ENTER” key is pressed, the
entry is completed. Then press “ENTER” key to search.
GOTO/WPT/SEARCH/M NO
CANCEL
E⇔W
PLOTTER
PAGE1
N⇔S
CLEAR
ENTER
START END
Move the cursor with the
left/right cursor key.
0000 ｰ 8299
0 1
2
3
456
7
89
A
B
C
D
EF
G
H
I
J
K
U
L
M
N
O
P
Q
R
S
VWX
Y
Z
&
#
_
T
.
Change the figure with
the rotary control.
4) Enter the number with the rotary control.
5) When completed, press the ENTER key to finish the settings.
left/right cursor key.
3) Place the cursor on to the next point to be changed with the
2) Enter the number with the rotary control.
1) Place the cursor on to the point to be changed with the left/righ
t
cursor key.
(b) Setting the mark color
Press the “COLOR” key to display the COLOR settings box. Select the color of the mark you
want to search for.
COLOR
BLU
DBL
Y
EL
RED
GRN
5
PNK
6 WHT
7 ALL
4
3
2
1
0
Use the up / down key to set the color.
The mark color that has been set is displayed in
the soft menu.
If ALL is selected, all colors will be assigned fo
r
the search.
6-24 0093161022-06