Konica Minolta SONIMAGE HS2 - Patient Information Entry Fields

3.3 Registering Patient Information
100
Item Functions
[Operator]
*
2
Enter an operator.
• The entered operators can be selected from the pull-down menu.
• The 20 latest used names are displayed in the pull-down menu.
• If the number of registered names exceeds 20, the oldest name will be deleted.
• The registered names can be deleted on the setup screen.
[Height]
Enter height.
• You can set the unit.
cm: Available from 0 to 299.9
ft: Available from 0 to 9
in: Available from 0 to 11
Refer to "System Screen"of the "Operation Manual: Applications".
[Weight]
Enter weight.
• You can set the unit.
Kg: Available from 0.0 to 499.9
Lb: Available from 0.0 to 999.9
Refer to "System Screen" of the "Operation Manual: Applications".
[BSA]
Calculate from entered height and weight.
• The unit is as follows.
m
2
: Available from 0.0 to 99.99
• If no BSA value is provided, an application measurement label using BSA as calculation ele-
ment cannot be calculated.
[Accession No.]
*
3
Enter a unique examination number.
*
1:
•
The following letters cannot be entered: "^", "\", "=", "/", "*", "?", " " ", "<", ">", "|", "%", and ":".
•
Do not assign any IDs indicated in 1) through 5) below.
1) "."
2) ".."
3) "CON", "PRN", "AUX", "NUL", "COM0" to "COM9", "LPT0" to "LPT9"
4) Begins with "CON.", "PRN.", "AUX.", "NUL.", "COM0." to "COM9." or "LPT0." to "LPT9."
5) Ends with "." or " "
• Do not assign an ID that di󰀨ers only in case (upper / lower case) from the one that already exists to a di󰀨erent patient.
• When entering an ID, you can set the system to use zero padding (adding zeros to the start of a number so that it ends up a
specic number of digits long) or automatically enter a particular string of characters at the start of the ID. Refer to the item
"ID format" under "Patient Screen" in the "Operation Manual: Applications".
*
2: The following letters cannot be entered: "^", "\" and "=".
*
3: The following letters cannot be entered: "\".