Konica Minolta SONIMAGE HS2 - 5.6.8 Voice Control

To Next Page

To Previous Page

5.6 Common Functions

216

5.6.8 Voice Control

This function controls the device through the voice input of registered commands. If a USB microphone is not con-

nected, voice reception is disabled, regardless of the settings.

Refer to "[Voice Control Settings] screen" of the "Operation Manual: Applications", regarding registering voice com-

mands.

You must have the optional "Voice Control License" to use this. Contact your service representative.

Press the [Menu] button > (voice reception button) on the [Other] tab.

• When the button appears blue, voice reception is enabled.

Face the USB microphone that is connected and input a voice command.

CAUTION

•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

• We recommend adding a wake word to voice commands to prevent misrecognition of voice commands. For details,

refer to “[Voice Control Settings] screen" in the "Operation Manual: Applications".

• If you have registered a voice command, be sure to do a voice recognition test to conrm that it is recognized.

• Place the USB microphone in a safe place where voice can be easily recognized depending on the operating envi-

ronment.

• The accuracy of recognition may vary greatly depending on the usage environment. Do the tests in the environment

in which you actually use the device.

•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

IMPORTANT

• In the interests of safety, be sure to conrm the operation of the voice command by the connected USB microphone

before use.

• Start up the system after connecting the USB microphone. If you connect the USB microphone after starting up the

system, voice commands may not be received.

• Connect the USB microphone to the USB2.0 port on the rear panel.

• If voice commands are not recognized about 1 minute while voice reception is enabled, disconnect the USB micro-

phone and connect it again.

• If the registered voice command is not recognized, just operate the mini console keys or the touch panel.