Konica Minolta SONIMAGE HS2 - 7.2 Maintenance Check and Cleaning

236
Konica Minolta strives to ensure consistent product quality from manufacturing to installation in order to ensure that
the users receive products with the best possible safety and reliability characteristics. However, the users are re-
sponsible for maintaining and operating the product after purchase.
7.2.1 Maintenance Check
Check and clean the system before and after use as described in "7.1 Maintenance Checks Before and After Use".
Also, perform the following maintenance checks whenever necessary.
Check category Check item Check interval
Cleaning
Clean and disinfect the transducer.
Refer to "8.1.6 Cleaning and Disinfection".
Clean the holder.
Clean the Reference Signal Unit.
Clean the LCD monitor.
Clean the system surface and the mini console.
Clean the vent holes.
Clean the trackball.
Clean the Pole Cart2, Power Extension Unit2, foot
switch, barcode reader, Three-Port Probe Unit, keyboard
and VESA Attachment.
Whenever necessary.
• See the section below for cleaning proce-
dures.
Backup
Back up the preset function, the user-dened data and
the patient data (study data).
Whenever necessary.
• Refer to "3.7 Data Backup".
7.2 Maintenance Check and Cleaning