Konica Minolta SONIMAGE HS2 - 7.2.2 Cleaning Procedures

To Next Page

To Previous Page

237

7.2 Maintenance Check and Cleaning

Chapter 7

7.2.2 Cleaning Procedures

Cleaning the LCD monitor

• Use a clean, soft cloth to clean the LCD surface.

• Use a soft cotton cloth or lens cleaning paper to clean the LCD surface.

• Do not hit or apply strong pressure to the LCD surface.

• If stains are di󰀩cult to remove, wipe it gently using a soft cloth slightly moistened with water and then wipe it using

a soft and dry cloth.

WARNING

•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

• Keep liquids away from the system, options or peripheral devices. Otherwise there is a risk of electric shock.

•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

CAUTION

• Turn the power OFF and disconnect the power supply cord, and remove the battery before cleaning the system. Oth-

erwise, there is a risk of electric shock.

IMPORTANT

• Never use organic solvents (such as benzine, paint thinner, and alcohol) or abrasive cleaners to prevent the damage

to the system surface or the LCD screen.

• Do not use mild detergent to clean the LCD surface to prevent the damage.

• Do not let water drops remain on the LCD screen to prevent a risk of failure.

Cleaning the system surface and the mini console

• Wipe o󰀨 stains using a soft cloth moistened with a mild detergent.

• Clean around the switches or keys on the mini console using cotton swabs.

Cleaning the vent holes

• Wipe o󰀨 stains using a soft cloth moistened with a mild detergent.

Cleaning and disinfecting the transducer

• Refer to "8.1.6 Cleaning and Disinfection".

Cleaning the holder

• Wipe o󰀨 any stains on the holder using a soft dry cloth.

• If it is di󰀩cult to remove stains, wipe them o󰀨 using a soft cloth moistened with mild detergent.

Cleaning the Reference Signal Unit

• Refer to "4.7 ECG Mode".