235
7.1 Maintenance Checks Before and After Use
Chapter 7
7.1.3 Check after Turning OFF the Power
Check the items below after turning OFF the power.
No. Item
(1)
There should be no deformation, damage, or dirt on the system.
• Clean the system when there is any dirt. Refer to "7.2 Maintenance Check and Cleaning" and "8.1.6 Cleaning and
Disinfection".
(2) There should be no loosened screws.
(3) There should be no damage to the power supply cord, and/or loosened connectors.
(4)
There should be no dirt and abnormality (projection, cracking, chasm, sharp-edge or peeling) on the appearance of the
transducer, cable, or connector.
• Clean and disinfect the transducer referring to "7.2.2 Cleaning Procedures" and "8.1.6 Cleaning and Disinfection".
To Next Page