Konica Minolta SONIMAGE HS2 - Page 32

Labels
32
CAUTION
Barcode reader
• Do not damage acrylic window of the barcode read-
er. Doing so may cause breakdown.
• Do not put heavy thing on the cable of the barcode
reader or close it to a heater. Doing so may cause
breakdown, an electric shock or a re.
• Do not pour water or any liquid on the barcode
reader. Doing so may cause breakdown, an electric
shock or a re.
• Do not use the barcode reader in a hot place; for
example, exposed to direct sunlight, or in front of a
heater. Doing so may cause breakdown, an electric
shock or a re.
• Do not use the barcode reader in dust or high
humidity environment. Doing so may cause break-
down, an electric shock or a re.
• Do not disassemble the barcode reader. Doing so
may cause breakdown.
• Do not give long-term vibration or intense impact
to the barcode reader. Doing so may cause break-
down.
• Do not leave the barcode reader in sudden chang-
es in temperature. Doing so may cause breakdown
or deformation of the casing.
• Do not wipe the barcode reader using chemical
agents. Doing so may cause breakdown.
• Do not connect the barcode reader to any connec-
tor other than USB connector of the system. Doing
so may cause breakdown.
• Do not look directly into a laser beam of the bar-
code reader.
• Do not disassemble and look inside of the barcode
reader. Doing so may cause damage to the eye.
• Do not connect multiple barcode readers to one
system. It causes the system to malfunction.
• Check that the patient information read by the bar-
code reader is correct.
CAUTION
Mini console switch conguration
• Do not press two or more switches on the mini
console simultaneously. System malfunction may
result. The operation of the USER LOG output func-
tion (refer to the "Operation Manual: Applications")
is excluded.
• The switch conguration on the mini console of this
system can be changed. The switch settings may
therefore di󰀨er depending on the system. Conrm
the switch conguration of your system before use.
• The descriptions in this operation manual are
based on the factory default switch configuration.
If the switch configuration has been changed, the
differences between the current configuration and
the default conguration must be understood before
use.
• The guaranteed operating angle of the trackball is
30 degrees or less with respect to the horizon. If
the angle is greater than that, do not use the track-
ball, just operate the touch panel or the push or dial
buttons of the mini console.