COMBI P9: MFX/TFX/LFO (Master/Total Effect/LFO) 9–1: Routing
99
COMBI P9: MFX/TFX/LFO (Master/Total Effect/LFO)
Here, you can make settings for the master effects and the
total effect. For instance, you can:
• Route a sound to the master effects and the total effect
• Make detailed settings for master effects and total effect
For more information, please see “Effect Guide” on
page 235.
9–1: Routing
• Here you can specify the type of master effects 1, 2 and
total effect, and turn them on/off.
• The master effects are sent to the L/R bus. The total effect
is inserted into the L/R bus.
These parameters are the same as in Program mode. For
more information, please see “9–1: Routing” on page 61.
9–1a: Combination Name
These are the bank, number, and name of the current
Combination. For more information, please see “0–1(2)a:
Combination Select” on page 70.
9–1b: MFX1, 2
MFX1:
MFX1 [000...193]
MFX1 On/Off [Off, On]
Return 1 [000...127]
MFX2:
MFX2 [000...171]
MFX2 On/Off [Off, On]
Return 2 [000...127]
Chain:
Chain On/Off [Off, On]
Chain Direction [MFX1→MFX2, MFX2→MFX1]
Chain Level [000...127]
For more information, please see “9–2: MFX1” on page 62.
9–1c: TFX
TFX:
TFX [000...171]
TFX On/Off [Off, On]
For more information, please see “PROG P9: MFX/TFX/LFO
(Master/Total Effect/LFO)” on page 61.
9–1d: Master Volume
Master Volume [000...127]
For more information, please see “9–1c: Master Volume” on
page 62.
V
9–1: Menu Command
•0: Write Combination see p. 101
•1: Exclusive Solo see p. 64
•2: Auto Setup Song see p. 101
•3: Copy MFX/TFX see p. 67
•4: Swap MFX/TFX see p. 67
For more information, please see “Combination: Menu
Command” on page 101.
9–2: MFX1
Here, you can edit the parameters of the effect you selected
for MFX1 in the P9: MFX/TFX/LFO– Routing page.
9–2a: MFX1
MFX1 On/Off [Off, On]
This turns master effect 1 on/off. This is linked with the on/
off setting in the P9: MFX/TFX/LFO– Routing page.
Ch (Control Channel) [Ch01...16, G ch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master effect.
Ch01…Ch16: The specified MIDI channel will be used for
control.
G ch: The global MIDI Channel (Global 1–1a) will be used
for control. Normally you will use the G ch setting.
P (Effect Preset)
[P00, P01...15, U00...15, ---------------]
With Effect Presets, you can easily store and recall all of the
settings for an individual effect. You can store up to 16 user
presets for each effect type, in addition to 15 re‐writable
factory presets.
To Next Page
Loading...
