Korg Krome - Mono;Mono Parallel (Mono;;Mono)

Mono/Mono Parallel (Mono//Mono) 126: Reverb - Gate
317
Mono/Mono Parallel (Mono//Mono)
127: P4EQ // P4EQ (Parametric 4‐Band EQ // Parametric 4‐
Band EQ) through 171: BPM Dl // BPM Dl (Multitap BPM
Delay // Multitap BPM Delay) are parallel effects.
The pan and effect balance of each effect can be set
independently.
In the screen, the L‐side is shown as [1], and the R‐side as
[2].
These provide various combinations of 4‐band EQ,
Compressor, Limiter, Exciter, Overdrive, Wah, Chorus/
Flanger, Phaser, and Multitap Delay, as described below.
P4EQ (4-band EQ)
Comp (Compressor)
Limiter
Exciter
0D/HG (Overdrive)
P4EQ
a Trim 0...100 Sets the input level
b
B1 Cutoff [Hz] 20...1.00k
Sets the center frequency of
Band 1
Q 0.5...10.0
Sets the bandwidth of Band 1
p.255
Gain [dB] –18.0...+18.0 Sets the gain of Band 1
c
B2 Cutoff [Hz] 50...5.00k
Sets the center frequency of
Band 2
Q 0.5...10.0
Sets the bandwidth of Band 2
p.255
Gain [dB] –18.0...+18.0 Sets the gain of Band 2
d
B3 Cutoff [Hz] 300...10.00k
Sets the center frequency of
Band 3
Q 0.5...10.0
Sets the bandwidth of Band3
p.255
Gain [dB] –18.0...+18.0 Sets the gain of Band 3
e
B4 Cutoff [Hz] 500...20.00k
Sets the center frequency of
Band 4
Q 0.5...10.0
Sets the bandwidth of Band 4
p.255
Gain [dB] –18.0...+18.0 Sets the gain of Band 4
f
L Wet/Dry
(R Wet/Dry)
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
g L Pan (R Pan)
L000...C064...R
127
Sets the stereo image
COMPRESSOR
a Sensitivity 1...100 Sets the sensitivity p.251
b Attack 1...100 Sets the attack level p.251
c Output Level 0...100 Sets the output level
d EQ Trim 0...100 Sets the EQ input level
e
Pre LEQ Gain
[dB]
–15...+15 Sets the gain of Low EQ
Pre HEQ Gain
[dB]
–15...+15 Sets the gain of High EQ
f
L Wet/Dry
(R Wet/Dry)
Dry,1 : 99... 99
: 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
g L Pan (R Pan)
L000...C064...R
127
Sets the stereo image
LIMITER
a Ratio
1.0 : 1...
50.0 : 1, Inf : 1
Sets the signal compression ratio
p.307
b
Threshold
[dB]
–40...0
Sets the level above which the
compressor is applied p.307
c Attack 1...100 Sets the attack time
d Release 1...100 Sets the release time
e
Gain Adjust
[dB]
–Inf,
–38...+24
Sets the output gain p.307
f
L Wet/Dry
(R Wet/Dry)
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
g L Pan (R Pan)
L000...
C064...R127
Sets the stereo image
EXCITER
a Exciter Blend –100...+100
Sets the intensity (depth) of the
Exciter effect p.256
b
Emphasis
Frequency
0...70
Sets the frequency range to be
emphasized p.256
c Trim 0...100 Sets the EQ input level
d
Pre LEQ Gain
[dB]
–15...+15 Sets the gain of Low EQ
e
Pre HEQ Gain
[dB]
–15...+15 Sets the gain of High EQ
f
L Wet/Dry
(R Wet/Dry)
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
g L Pan (R Pan)
L000...C064...R
127
Sets the stereo image
OD/HI GAIN
a
Drive Mode
Overdrive, Hi-
Gain
Switches between overdrive and
high-gain distortion
Drive 1...100
Sets the degree of distortion
p.263
b
Output Level 0...50 Sets the output level p.263
Src Off...Tempo
Selects the modulation source
for the output level
Amt –50...+50
Sets the modulation amount of
the output level
c
Low Cutoff
[H
z
]
20...1.00k
Sets the center frequency for
Low EQ (shelving type)
Gain [dB] –18...+18 Sets the gain of Low EQ
d
Mid1 Cutoff
[Hz]
300...10.00k
Sets the center frequency for
Mid/High EQ 1 (peaking type)
Q 0.5...10.0
Sets the band width of Mid/High
EQ 1 p.255
Gain [dB] –18...+18 Sets the gain of Mid/High EQ 1
e
Mid2 Cutoff
[Hz]
500...20.00k
Sets the center frequency for
Mid/High EQ 2 (peaking type)
Q 0.5...10.0
Sets the band width of Mid/High
EQ 2 p.255
Gain [dB] –18...+18 Sets the gain of Mid/High EQ 2
f
L Wet/Dry
(R Wet/Dry)
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
g L Pan (R Pan)
L000...C064...R
127
Sets the stereo image