Modulation and Pitch Shift (Mod./P.Shift) 055: Stereo Tremolo
281
055: Stereo Tremolo
This effect modulates the volume level of the input signal.
The effect is stereo, and offsetting the LFO of the left and
right phases from each other produces a tremolo effect
between left and right.
a: LFO Waveform
This parameter sets the basic shape of the LFO. The Vintage
waveform models classic guitar‐amp tremolo.
b: LFO Phase [degree]
This parameter determines the difference between the left
and right LFO phases. A higher value will simulate the auto‐
pan effect in which the sound is panned between left and
right.
056: TEX Treml (TEX Tremolo)
This models the highly‐acclaimed tremolo circuit that was
built into a US‐made combo amp. The Spread setting lets
you create a pan effect that wavers between left and right.
057: St. Env. Tremolo
(Stereo
Envelope Tremolo)
This effect uses the input signal level to modulate a stereo
tremolo (LFO volume modulation). For instance, you can
create a tremolo effect that becomes deeper and faster as the
input gets more quiet.
a
LFO
Waveform
Triangle, Sine,
Vintage, Up,
Down
Selects the LFO Waveform
p.281
LFO Shape –100...+100
Changes the curvature of the
LFO Waveform p.258
b
LFO Phase
[degree]
–180...+180
Sets the LFO phase difference
between the left and right
p.281
c
LFO
Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO p.259
Src Off...Tempo
Selects a modulation source for
LFO speed
Amt
–20.00...
+20.00
Sets the modulation amount of
LFO speed
d
MIDI Sync Off, On
When this is on, the LFO speed is
set by BPM, Base Note, and
Times, instead of Frequency
p.257
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo;
40–300 sets the tempo manually
for this individual effect p.257
Base Note ...
Selects the type of notes that
specify the LFO speed p.257
Times x1...x32
Sets the number of notes that
specify the LFO speed p.257
e
LFO Type
Individual,
Common1,
Common2
Selects either (individual) LFO,
Common FX LFO1, or Common
LFO2 p.257
Common
LFO Offset
[deg]
–180...+180
Sets the phase offset when Type
= Common 1 or Common 2
p.257
f
Depth 0...100
Sets the depth of LFO
modulation
Src Off...Tempo
Selects the modulation source of
the depth of modulation
Amt –100...+100
Sets the modulation amount of
the depth of modulation
g
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO Phase
LFO: Tri/Sin/Vintage/Up/Down
LFO Shape
Tremolo
Tremolo
Tremolo - LFO Waveform
Triangle Sine Vintage Up Down
a
Speed [Hz] 0.10...10.0 Sets the tremolo speed
Src Off...Tempo
Selects a modulation source for
Speed [Hz]
Amt –100...+100
Sets the modulation amount for
Speed [Hz]
b
Depth 0...100 Select the tremolo depth
Src Off...Tempo
Selects a modulation source for
Depth
Amt –100...+100
Sets the modulation amount for
Depth
c Spread 0...100
Sets the width of the stereo
image of the effect sound
d Level Adjust 1...100 Sets the output level
e
Wet/Dry
–Wet...
–1 : 99, Dry,
1 : 99...Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
a
Envelope
Sens
0...100
Sets the envelope’s sensitivity to
the input signal
Envelope
Shape
–100...+100 Sets the envelope’s curvature
b
LFO
Waveform
Triangle, Sine,
Vintage
Selects the LFO Waveform
LFO Shape –100...+100
Changes the curvature of the
LFO Waveform p.258
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Spread
LFO
Tremolo
Tremolo
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO Phase
LFO Shape
Envelope Sens
+
Envelope
LFO: Tri/Sin/Vintage
Envelope Shape
Tremolo
Tremolo
To Next Page
Loading...
