Korg Krome - Using Effects; Effects Overview

69
Combination mode
COMBI Page Select
You can use the following ways to select the pages in
Combination mode.
1. Press the PAGE button to access “Page Select.”
Alternatively, press the mode button on the upper left side
of the display, and then press the right side of the menu.
“Page Select” shows an abbreviated name for each page.
The page in which you were prior to pressing the PAGE
button is shown in light blue.
2. Select the desired page in the display.
Other ways to select pages
• Hold down the PAGE button and press a numeric keys,
0–9, to specify a page number; you will move to the
corresponding page.
For example if you want to access the P3: Timbre Param
page, hold down the PAGE button and press numeric
key 3.
• Pressing the EXIT button will take you to the P0: Play
page. If a page other than the Program T01–08 page is
selected, pressing the EXIT button will take you to the
Program T01–08 page.
Page Main content
PLAY
P0: Play
Select and play combinations. (see p.70)
Program selection for each timbre. (see
p.71)
Pan and volume settings etc. for each
timbre. (see p.73)
Simple arpeggiator editing. (see p.74)
Editing from the Tone Adjust (see p.75)
EDIT
P1: Controllers
SW1, 2, and knob function settings. (see
p.78)
P2: EQ EQ settings for each timbre. (see p.79)
P3: Timbre Param
Various parameter settings for each
timbre (MIDI channel, OSC selection,
Pitch setting, etc.) (see p.81)
P4: Zone/Delay
Key split and layer settings.
(Key zone and velocity zone) (see p.84)
Time delay from note‐on to beginning of
sound. (see p.86)
P5:
MIDI Filter
MIDI transmit/receive filter settings. (see
p.87)
ARP & DRUM TRACK
P7: Arpeggiator/
Drum Track
Arpeggiator settings. (see p.92)
Drum track settings. (see p.93)
EFFECT
P8: Routing/IFX
Oscillator output bus and master effect
send level settings. (see p.95)
Insert effect routing, selection, and
settings. (see p.97)
P9: MFX/TFX/
LFO
Master effect routing, selection, and
settings. (see p.99)
Total effect selection and settings. (see
p.100)
Common FX LFO settings (see p.100)