Korg Krome - 004: Multiband Limiter; 005: St.masteringlimtr (Stereo Mastering Limiter); 006: Stereo Gate

Dynamics (Dynamic) 004: Multiband Limiter
253
equalizer allows you to set the Limiter to respond to any
frequency band.
004: Multiband Limiter
This effect applies the Limiter to the low range, mid range,
and high range of the input signal. You can control
dynamics for each range to adjust the sound pressure of the
low range, mid range, and high range in a different way
from the EQ.
e: Low Offset [dB]
f: Mid Offset [dB]
g: High Offset [dB]
These parameters set the gain of the trigger signal.
For example, if you do not want to apply compression to the
high range, reduce the High Offset value down below the
Threshold level. In this way, the high range limiter will not
respond, and compression will not be applied.
005: St.MasteringLimtr (Stereo
Mastering Limiter)
This is a stereo limiter that is optimized for mastering songs.
006: Stereo Gate
This effect mutes the input signal when it falls below a
specified level. You can also invert the on/off status of the
gate, or use note‐on/off messages to turn the gate on/off
directly.
a Ratio
1.0 : 1...50.0 : 1,
Inf : 1
Sets the signal compression ratio
p.252
b
Threshold
[dB]
–40...0
Sets the level above which the
compressor is applied p.252
c Attack 1...100 Sets the attack time p.252
d Release 1...100 Sets the release time p.252
e
Low Offset
[dB]
–40...0
Gain of the low-range trigger
signal p.253
f
Mid Offset
[dB]
–40...0
Gain of the mid-range trigger
signal p.253
g
High Offset
[dB]
–40...0
Gain of the high-range trigger
signal p.253
h
Gain Adjust
[dB]
–Inf,
–38...+24
Sets the output gain p.252
Src Off...Tempo
Selects the modulation source
for the output gain
Amt –63...+63
Sets the modulation amount of
the output gain
i
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Gain Adjust
Mid Oset
Low Oset
High Oset
Envelope - Control
Envelope - Control
Envelope - Control
Low
Mid
High
Band-Pass Filters
+
Limiter
Limiter
Limiter
a
Threshold
[dB]
–30.0...0.0
Sets the level above which the
compressor is applied p.252
b
Out Ceiling
[dB]
–30.0...0.0 Sets the output gain
c
Release
[msec]
0.50...1000.0 Sets the release time p.252
d
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
a
Envelope
Source
D-mod,
Input,
FX Control 1,
FX Control 2
Selects the source to control the
gate: D-mod control, or use the
input signal or FX Control Bus 1
or 2 as a trigger
p.252
Fx Ctrl Trim 0...100
Sets the trigger input level from
FX Control Bus 1/2
b
Envelope
Select
L/R Mix,
L Only,
R Only
Selects the control signal: left
and right linked, left only, or right
only p.252
Src Off...Tempo
Selects the source that will
control the gate when Envelope
Src = D-mod
c
Threshold 0...100
Sets the level at which gating is
applied p.254
Polarity +, –
Switches the polarity of gating
p.254
d
Attack 1...100 Sets the attack time p.254
Release 1...100 Sets the release time p.254
e
Delay Time
[msec]
0...100
Sets the delay time for the gate
input p.254
f
Side PEQ
Insert
Off, On
Switches the trigger signal
equalizer on/off p.252
Trigger
Monitor
Off, On
Switches between monitoring
the effect output and the trigger
signal p.252
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Limiter
Limiter
Out Ceiling
Out Ceiling
Envelope - Control
+
Left
Right
FX Control BUS 1
FX Control BUS 2
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Envelope Source
Gain Adjust
Gain Adjust
Side PEQ
Envelope - Control
Envelope - Control
Trigger Monitor
+
Envelope Select
Gate
Delay
Gate
Delay
D
-mod