Korg Krome - Page 262

254
c: Threshold
d: Attack
d: Release
Threshold specifies the level at which gating occurs when
Envelope Select is set to L/R Mix, L Only, or R Only.
Attack and Release specify the attack time and release time
of the gate.
c: Polarity
This inverts the polarity of the gate on/off operation. With
the “–” setting, the gate will close when the input signal
exceeds the specified level. The direction in which the
modulation source opens or closes the gate will also be
reversed.
e: Delay Time [msec]
This sets the delay time for the input to the gate. When using
shorter Attack Time settings, you can lengthen the Delay
Time so that the sound is input after the gate opens.
g
Side PEQ
Cutoff [Hz]
20...12.00k
Sets the center frequency of the
equalizer for the trigger signal
p.252
Q 0.5...10.0
Sets the bandwidth of the
equalizer for the trigger signal
p.252
Gain [dB] –18.0...+18.0
Sets the gain of the equalizer for
the trigger signal p.252
h
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
Input Level
Output Level
Threshold
Louder
Louder
Threshold
Attack=1
Release=1
Attack=100
Release=100
Dry
Wet
Wet
Attack
Release
Gate - Attack / Release
Gate - Threshold