Korg Krome - 047: St. Random Phaser (Stereo Random Phaser)

Chorus, Flanger, and Phaser (Cho/Fln Phaser) 047: St. Random Phaser (Stereo Random Phaser)
275
c: Mix
d: Wet/Dry
The Mix parameter specifies the amount of effect sound
relative to the direct sound. A setting of 0 produces the
direct sound, a setting of about 50 produces chorus, and a
setting of 100 produces a vibrato effect. If you set the Wet/
Dry parameter to Wet, the sound will be output with the
mix balance specified by Mix.
047: St. Random Phaser
(Stereo Random Phaser)
This is a stereo phaser. The effect uses a step‐shape
waveform and random LFO for modulation, creating a
unique phasing effect.
d
Wet/Dry
–Wet...
–1 : 99, Dry,
1 : 99...Wet
Sets the balance between the
effect and the dry input p.275
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
a
LFO
Waveform
Step-Tri, Step-
Sin, Random
Selects the LFO Waveform p.259
LFO Phase
[degree]
–180...+180
Sets the LFO phase difference
between the left and right
p.259
b
LFO
Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO p.257
Src Off...Tempo
Selects the modulation source
commonly used for LFO speed
and step speed
Amt
–20.00...
+20.00
Sets the modulation amount of
LFO speed
c
LFO Step
Frequency
[Hz]
0.05...50.00 Sets the LFO step speed p.259
Amt
–50.00...
+50.00
Sets the modulation amount of
LFO step speed
d
MIDI Sync Off, On
When this is on, the LFO speed is
set by BPM, Base Note, and
Times, instead of Frequency
p.257
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo;
40–300 sets the tempo manually
for this individual effect p.257
Base Note ...
Selects the type of notes that
specify the LFO speed p.257
Times x1...x32
Sets the number of notes that
specify the LFO speed p.257
e
Step Base
Note
...
Selects the type of notes to
specify the LFO step speed
p.257
Times x1...x32
Sets the number of notes to
specify the LFO step speed
p.257
f
LFO Type
(Step)
Individual,
Common1,
Common2
Selects either (individual) LFO,
Common FX LFO1, or Common
LFO2 p.257
Common
LFO Offset
[deg]
–180...+180
Sets the phase offset when Type
= Common 1 or Common 2
p.257
LFO: Step-Tri/Random
Left
Right
Resonance
LFO Phase
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
Phaser
Phaser
g
Manual 0...100
Sets the frequency to which the
effect is applied
Src Off...Tempo
Selects the modulation source
for the LFO modulation
Amt –100...+100
Sets the modulation amount of
the LFO modulation
h Depth 0...100
Sets the depth of LFO
modulation
i
Resonance –100...+100
Sets the resonance amount
p.273
High Damp
[%]
0...100
Sets the resonance damping
amount in the high range
p.274
j
Wet/Dry
–Wet...
–1 : 99, Dry,
1 : 99...Wet
Sets the balance between the
effect and the dry input
p.259, p.273
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry