PROG P7: ARP/DT (Arpeggiator/Drum Track) 7–1: ARP Setup
53
PROG P7: ARP/DT (Arpeggiator/Drum Track)
Here you can make settings for the arpeggiator used by the
program.
You can make settings so that when you select a program,
these arpeggiator settings will automatically switch to the
arpeggiator settings that are memorized in the selected
program. (Global P0: 0–1c Load ARP when changing
“Program” on page 195)
The arpeggiator can be switched on/off by the ARP button.
When on, the key LED will light up.
The settings of the ARP button, TEMPO, arpeggio control
(ARP) GATE, VELOCITY, SWING and STEP knobs can be
saved for each program.
Note: The parameters below that are marked with “*” can
also be edited in “P0: Play‐ Arpeggiator.”
These settings will be valid when “Load ARP when
changing” Program (Global 0–1c) is checked.
You can control the arpeggiator from an external
sequencer, or record note data generated by the
arpeggiator onto an external sequencer. (See OG
page 96)
Note: Pattern, Resolution, Octave, Sort, Latch, Key Sync.,
Keyboard, and (Tempo) can also be set from the P0: Play,
Arpeggio page.
7–1: ARP Setup
7–1a: Tempo
(Tempo)* [040.00...300.00, EXT]
Sets the tempo, expressed as beats per minute.
You can also adjust this by turning the front panel TEMPO
knob. Alternatively, you can set the tempo by pressing the
TAP button at the desired interval.
When MIDI Clock (Global P1: 1–1b) is set to either
External MIDI or External USB, this parameter will
indicate EXT, and the arpeggiator will synchronize to
the MIDI Clock received from an external MIDI device.
If MIDI Clock is set to Auto, this indication will be
shown only if MIDI clock data is being received from
an external device. When the EXT indication is shown,
the arpeggiator etc. will synchronize to MIDI clock data
from the external MIDI device.
7–1b: Arpggiator Setup
Pattern* [P0...P4, U0000(INT)...U0899(INT),
U0900(USER)...U1027(USER)]
Selects the arpeggio pattern.
Note: U0000(INT)–U1027(USER) are rewritable. Use Global
P6: Arpeggio Pattern to create arpeggio patterns.
Example: Preset pattern
The way in which the pattern is played will depend on
settings such as Octave and Sort. P0–P4 in the following
diagrams show how the arpeggio will be played when
Octave is set to 1, and Sort is checked. P4: RANDOM is only
one possibility.
P0: UP
P1: DOWN
P2: ALT1
P3: ALT2
P4: RANDOM
Octave* [1, 2, 3, 4]
Specifies the number of octaves in which the arpeggio will
be played.
If a user arpeggio pattern is selected, the range of the
arpeggio will depend on the Octave Motion (Global P6:
6–1b) setting.
Preset/User No Contents
P0...P4 Preset arpeggio patterns
U0000(INT)...U0899(INT) Preloaded arpeggio patterns
U0900(USER)...U1027(USER) User arpeggio patterns
UP
DOWN
ALT1
ALT2
To Next Page
Loading...
