COMBI P2: EQ 2–1: EQ Trim T01–08, 2–2: EQ Trim T09–16
79
COMBI P2: EQ
2–1: EQ Trim T01–08,
2–2: EQ Trim T09–16
Here, you can set the signal level that enters the EQ of
timbres 1–8 and 9–16.
2–1(2)a: Combination Name, Tempo
Bank, Combination Number & Name
These are the bank, number, and name of the current
Combination.
For more information, please see “0–1(2)a: Combination
Select” on page 70.
(Tempo) [040.00...300.00, EXT]
For more information, please see “ (Tempo)” on page 71.
2–1(2)b: Timbre Info
Selected Timbre Info:
This area displays information about the timbre selected for
editing – T: timbre number/program bank/number/name,
Ch: MIDI channel number.
Timbre Number:
This indicates the timbre number. The various parameters
below each timbre number make settings for the
corresponding timbre.
Timbre Category:
This shows the abbreviated category name of the Program
assigned to the Timbre.
2–1(2)c: Trim
Timbre 01 (Timbre Number):
Auto Load Prog EQ [Off, On]
When you first load a Program into a Timbre, this parameter
determines whether or not the Program’s EQ settings will be
loaded as well.
Once the Program has been loaded, you can change any or
all of the EQ settings as desired. All such edits are stored in
the Combination, without affecting the original Program.
Regardless of this setting, subsequent edits to the Program’s
EQ in Program mode will not affect the Combination.
On (checked): When you switch the timbre's program, the
current EQ settings will be cleared, and the 3‐band EQ
values specified by the program will be loaded
automatically. Normally you will leave this checked. The
timbre's program can be switched by using Program Select
(Combi 0‐1(2)b) or by receiving a MIDI program change.
You are free to edit the 3‐band EQ settings that have been
automatically loaded. Make adjustments for each timbre
relative to the settings of the program, and then save the
combination.
Off (unchecked): The Program’s EQ settings won’t be
loaded. Use this if you’ve set up the EQ in a specific way,
and then want it to stay unchanged while you try out
different Programs.
Bypass [On, Off]
If this is On (checked), all of the EQ will be disabled,
including Input Trim. Bypass is useful for comparing the
results of the EQ with the original signal.
Input Trim [00…99]
This controls the volume level going into the EQ. Note that
this parameter uses a linear scale; 50 is equivalent to –6 dB,
25 is the same as –12 dB, and so on.
High settings of the Low, Mid, and High Gain controls can
cause substantial increases in the overall level. You can
compensate for this by turning down the input trim.
Timbre 02...08, 09...16 (Timbre Number):
Here, you can make settings for timbres 2–8 and 9–16. They
are the same as for timbre 1. For more information, please
see “Timbre 01 (Timbre Number):” above.
V
2–1(2): Menu Command
•0: Write Combination see p. 101
•1: Exclusive Solo see p. 64
•2: Auto Song Setup see p. 65
•3: Copy from Program see p. 101
For more information, please see “Combination: Menu
Command” on page 101.
Select Timbre Info
Timbre Number
Timbre Category
To Next Page
Loading...
